Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
290 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
ipv6 route <prefix> <prefix len>
(
[<NextHop>]
{
vlan <id>[<administrative distance>] [unicast]|[<administrative distance>] [unicast]
| [<interface
-type> <interface
-id>][<administrative distance>] [unicast]
}
)
The parameters have the following meaning:
IPv6 address
Enter a valid IPv6 address.
Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
128: The node (host) itself
IPv6 address to which the selected addresses will be forwarded
Enter a valid IPv6 address.
Keyword for a VLAN connection
Number of the addressed VLAN
distance
Value for the administrative distance 0 ... 65535
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The entry is configured.
You delete a static entry from the IPv6 routing table with the no ipv6 route command.
You display the IPv6 routing table with the
show ipv6 route command.
To Next Page
Loading...
Need help?
General