Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
337
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call up the command with the following parameters:
no ipv6 dhcp relay [destination <prefix> {link
-local | <prefix Len> } [interface
{Vlan <vlan-id (1-4094)> | <interface-type> <interface-id>}]]
The parameters have the following meaning:
Keyword for the IPv6 address of the
destination DHCPv6 server
-
IPv6 address Enter a valid IPv6 address.
Link local address of the DHCP relay
-
Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
128: The node (host) itself
Shows that an interface description
-
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The DHCPv6 relay agent is disabled.
You enable the DHCPv6 relay agent with the ipv6 dhcp relay command.
You configure the interface as a router port with the
no switchport command.
You display the setting with the
show ipv6 dhcp interface command.
You display the statistics with the
show ipv6 dhcp relay statistics command.
To Next Page
Loading...
Need help?
General