Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
512 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no area <area-id>
[ {
stub | nssa | virtual-link <router-id> |default-metric |
{range {summary | Type7} | summary-prefix}
<IPv6-Prefix> <Prefix-Length>
} ]
The parameters have the following meaning:
Parameter
Description
Range of values / note
area-id
Area ID Specify the ID in the IPv4 address format
x.x.x.x = 0 ... 255
The area ID 0.0.0.0 is reserved for the backbone area and cannot be
deleted.
stub
Stub area
-
nssa
NSSA
-
virtual-link
Virtual link
-
router-id
ID of the router Specify the ID in the IPv4 address format
x.x.x.x = 0 ... 255
default-metric
Metric of the standard route
-
range
Address range
-
summary
LSA type 3
-
Type7
LSA type 7
-
summary-prefix
Address range of external
routes
-
IPv6-Prefix
IPv6 address
Enter a valid IPv6 address
Prefix-Length
Number of bits belonging to the
prefix
(from left to right)
1 ... 128 bits
128: The node (host) itself
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The area is removed or changed.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English