Siemens SCALANCE XR-500 - Page 547

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
547
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Requirement
● Layer 3 interface
● The router ID is configured.
● OSPFv3 routing is activated.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 ospf transmit-interval <1-1800>
The parameter has the following meaning:
Parameter
Description
Range of values / note
- Interval in seconds 1 ... 1800
Default: 1
Result
The interval is specified.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You reset the interval to the default with the
no ipv6 ospf transmit-interval command.
You display the configuration with the
show ipv6 ospf interface command.