Diagnostics
12.6 Syslog Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
820 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
no syslogserver { ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6 <ip6_addr>}
The parameters have the following meaning:
Keyword for an IPv4 address
IPv4 unicast address of the Syslog
Enter a valid IPv4 address.
Keyword for a domain name
Domain name (Fully Qualified Domain
Maximum of 100 characters
Keyword for an IPv6 address
IPv6 address of the Syslog server
Enter a valid IPv6 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The Syslog server is deleted.
You add a Syslog server with the syslogserver command.
To Next Page
Loading...
Need help?
General