6.5 Transfer Procedure (Using a Card)
6-42
6) Press the [Select Data] switch. The [Data Selection] dialog is displayed. The switch name
changes from [Select Data] to [Start].
7) Select the data to be transferred. In this example, press the [Select All] switch so that all data
will be transferred. Press the [Start] switch. The switch name changes from [Start] to
[Transferring].
8) When the data has been transferred successfully, the Main Menu screen is displayed again.
Data transfer has been completed.
F 1
F 2
F 3
F 4
F 5
F 6
F 7
SYSTEM
F 1
F 2
F 3
F 4
F 5
F 6
F 7
SYSTEM
F 1
F 2
F 3
F 4
F 5
F 6
F 7
SYSTEM
F 1
F 2
F 3
F 4
F 5
F 6
F 7
SYSTEM
When [Select All] or [Sys. Program] is selected as the data to be transferred, the Main Menu screen is
displayed on completion of transfer.
Otherwise, the following window is displayed when data transfer is completed.
Press the [OK] switch. The Card Transfer screen will appear. Return to the Main Menu screen using
the [Return] switch.
F 1
F 2
F 3
F 4
F 5
F 6
F 7
SYSTEM
To Next Page
Loading...