Siemens SCALANCE XR-500

Configuration
3.4 Configuration Save & Restore
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
115
Syntax
Call up the command with the following parameters:
show running-config
[{
syslog|dhcp|qos|stp|la|pnac|vlan<vlan-id(1-4094)>|
interface
{port-channel<port-channel-id(1-8)>|
<interface-type><interface-list>|
vlan<vlan-id(1-4094)>
}|
ssh|ssl|acl|ip|snmp|radius|rmon|igmp|sntp|http|
broadcast-blocking|multicast-blocking|locked-port|auto-logout|
time|ntp|auto-save|panel-button|cos-map|dscp-map|
output-rate-limit|unicast-blocking|ospf|vrrp|loopd|events}]
[all]
The parameters have the following meaning:
Parameter
Description
Range of values / note
syslog
Shows the configuration settings of the
Syslog function
-
dhcp
shows the configuration settings of the
Dynamic Host Configuration Protocol
-
qos
shows the configuration settings of
QoS (Quality of Service)
-
stp
Shows the configuration settings of the
Spanning Tree protocol
-
la
Shows the configuration settings of the
Link Aggregation function
-
pnac
shows the configuration settings of the
port-based network access control
-
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 ... 4094
interface
Keyword for a an interface description
-
port-channel
Keyword for a port channel connection
-
port-channel-id
Number of the addressed port channel
1 ... 8
interface-type
Type of interface
Enter a valid interface.
interface-list
Module no. and port no. of the interface
ssh
Shows the configuration settings of the
Secure Shell protocol
-
ssl
Shows the configuration settings of the
Secure Sockets Layer protocol
-
acl
Shows the configuration settings of the
access control lists
-
ip
Shows the configuration settings of the
Internet Protocol
-
snmp
Shows the configuration settings of the
Simple Network Management Protocol
-