Send documentation comments to mdsfeedback-doc@cisco.com
6-97
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug rd-reg
debug rd-reg
To enable debugging for the list of devices using the read-register feature, use the debug rd-reg
command in EXEC mode. To disable a debug command, use the no form of the command or use the no
debug all command to turn off all debugging.
debug rd-reg [device-name | register address]
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug rd-reg abc command is issued:
switch# debug rd-reg abc
Related Commands
device-name Specifies the device name for the required device.
register address Specifies the register address for the required device.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
To Next Page
Loading...
Need help?
General