Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
8-77
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
flex-attach virtual-pwwn
flex-attach virtual-pwwn
To map the real port WWN (pWWN) and a user-specific virtual pWWN, use the flex-attach
virtual-pwwn command. To disable the mapping, use the no form of the command.
flex-attach virtual-pwwn vpwwn pwwn pwwn
no flex-attach virtual-pwwn vpwwn pwwn pwwn
Syntax Description
Defaults None.
Command Modes Configuration mode
Command History
Usage Guidelines None.
Examples The following example shows how to map the real pWWN and a user-specific virtual pWWN on an
interface.
switch# config
Enter configuration commands, one per line. End with CNTL/Z.
switch# (config) flex-attach virtual-pwwn 20:04:00:a0:b8:16:92:18 pwwn
21:03:00:a0:b9:16:92:16
Related Commands
vpwwn Specifies the virtual pWWN chosen by the user.
pwwn pwwn Specifies the pWWN to be mapped to the user-specific virtual pWWN.
Note pWWN must not be logged in.
Release Modification
3.3(1a) This command was introduced.
Command Description
flex-attach
virtual-pwwn auto
Enables the FlexAttach virtual pWWN on a specific interface.
flex-attach
virtual-pwwn
interface
Sets the user-specific FlexAttach virtual pWWN.