Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
8-47
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fcs virtual-device-add
fcs virtual-device-add
To include a virtual device in a query about zone information from an FCS, use the fcs
virtual-device-add command in configuration mode. To remove a virtual device, use the no form of the
command.
fcs virtual-device-add [vsan-ranges vsan-ids]
no fcs virtual-device-add [vsan-ranges vsan-ids]
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines VSAN ranges are entered as vsan-ids-vsan-ids. When you specify more than one range, separate each
range with a comma. If no range is specified, the command applies to all VSANs.
Examples The following example shows how to add to one range of VSANs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcs virtual-device-add vsan-ranges 2-4
The following example shows how to add to more than one range of VSANs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# fcs virtual-device-add vsan-ranges 2-4,5-8
Related Commands
vsan-ranges vsan-ids Specifies one or multiple ranges of VSANs. The range is 1 to 4093.
Release Modification
3.1(2) This command was introduced.
Command Description
show fcs Displays fabric configuration server information.