Send documentation comments to mdsfeedback-doc@cisco.com
21-68
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
switch-priority
switch-priority
To configure the switch priority with the Call Home function, use the switch-priority command in Call
Home configuration submode. To disable this feature, use the no form of the command.
switch-priority {priority-value}
no switch-priority {priority-value}
Syntax Description
Defaults None.
Command Modes Call Home configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to configure the switch priority in the Call Home configuration.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# callhome
switch(config-callhome)# switch-priority 0
Related Commands
priority-value Specifies the priority level. 0 is the highest priority and 7 the lowest.
Release Modification
1.0(2) This command was introduced.
Command Description
callhome Configures the Call Home function.
callhome test Sends a dummy test message to the configured destination(s).
show callhome Displays configured Call Home information.
To Next Page
Loading...
Need help?
General