Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
25-11
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 25 V Commands
vsan database
Note Before you configure Interop mode 4 (or remove the configuration), you must suspend the VSAN. You
should unsuspend the VSAN only after you configure a VSAN-dependent switch WWN with the
McData OUI [08:00:88].
Examples The following examples show how to create multiple fabrics sharing the same physical infrastructure and
how to assign ports to VSANs.
switch# config terminal
switch(config)# vsan database
switch(config-db)#
switch-config-db# vsan 2
switch(config-vsan-db)# vsan 2 name TechDoc
updated vsan 2
switch(config-vsan-db)# vsan 2 loadbalancing src-dst-id
switch(config-vsan-db)# vsan 2 loadbalancing src-dst-ox-id
switch(config-vsan-db)# vsan 2 suspend
switch(config-vsan-db)# no vsan 2 suspend
switch(config-vsan-db)# vsan 2 interface fv2/8/2
switch(config-vsan-db)# vsan 2 interface iscsi 2/1
switch(config-vsan-db)# end
switch#
The following example shows how to suspend a VSAN and enable interop mode 4.
switch# config t
switch(config)# vsan database
switch(config-vsan-db)# vsan 100 suspend
switch(config-vsan-db)# vsan 100 interop 4
switch(config-vsan-db)# exit
Related Commands Command Description
vsan wwn Configures a WWN for a suspended VSAN that has interop mode 4 enabled.