Send documentation comments to mdsfeedback-doc@cisco.com
4-78
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
clear rscn session vsan
clear rscn session vsan
To clear a Registered State Change Notification (RSCN) session for a specified VSAN, use the clear
rscn session vsan command.
clear rscn session vsan vsan-id
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example clears an RSCN session on VSAN 1.
switch# clear rscn session vsan 1
Related Commands
vsan-id Specifies a VSAN where the RSCN session should be cleared. The ID of the
VSAN is from 1 to 4093.
Release Modification
3.0(1) This command was introduced.
Command Description
rscn Configures an RSCN.
show rscn Displays RSCN information.
To Next Page
Loading...
Need help?
General