Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
2-17
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 2 A Commands
attachpriv
attachpriv
To connect to a specific ILC linecard as a privilege, use the attach module command in EXEC mode.
attachpriv module slot-number
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines
Examples The following example shows how to connect to a specific ILC linecard as a privilege.
switch# attachpriv module 1
Attaching to module 1 ...
To exit type 'exit', to abort type '$.'
module-1# exit
Related Commands
module slot-number Specifies the slot number of the module.
Release Modification
3.1(3) This command was introduced.
Command Description
exit Disconnects from the module.
show module Displays the status of a module.