Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
20-38
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
rscn
rscn
To configure a registered state change notification (RSCN), a Fibre Channel service that informs Nx
ports about changes in the fabric, use the rscn command in configuration mode.
rscn {multi-pid | suppress domain-swrscn} vsan vsan-id
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example configures RSCNs in multi-PID format.
switch# config terminal
switch(config)# rscn multi-pid vsan 1
Related Commands
multi-pid Sends RSCNs in multi-PID format.
suppress domain-swrscn Suppresses transmission of domain format SW-RCSNs.
vsan vsan-id Configures VSAN information or membership. The ID of the VSAN is
from 1 to 4093.
Release Modification
1.0(2) This command was introduced.
Command Description
show rscn src-table Displays state change registration table,
show rscn statistics Displays RSCN statistics.