Send documentation comments to mdsfeedback-doc@cisco.com
21-51
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
span session
span session
To configure a SPAN session, use the span session command. To remove a configured SPAN feature or
revert it to factory defaults, use the no form of the command.
span session {session-id}
no span session {session-id}
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example shows how to configure a SPAN session.
switch# config terminal
switch(config)# span session 1
switch(config-span)#
The following example shows how to delete a SPAN session.
switch(config)# no span session 1
Related Commands
session-id Specifies the SPAN session ID. The range is 1 to 16.
Release Modification
1.0(2) This command was introduced.
Command Description
switchport Configures the switch port mode on the Fibre Channel interface.
span session Selects or configures the SPAN session and changes to SPAN configuration
submode.
destination interface Configures a SPAN destination interface.
source Configures a SPAN source.
suspend Suspends a SPAN session.
show span session Displays specific information about a SPAN session
To Next Page
Loading...
Need help?
General