Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-152
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show interface transceiver
revision is C
serial number is FNS11151B0V
FC Transceiver Type is X2 Medium
FC Connector Type is SC
Bit Encoding is NRZ
Protocol Type is 10GbE
Standards Compliance Codes :
10GbE Code Byte 0 : 10GBASE-SR
Fiber type Byte 0 : MM-Generic
Fiber type Byte 1 : Unspecified
Transmission Range is 30 (in 10m increments)
cisco extended id is Unknown (0x0)
no tx fault, rx loss, no sync exists, Diag mon type 193
SFP Detail Diagnostics Information
----------------------------------------------------------------------------
Alarms Warnings
High Low High Low
----------------------------------------------------------------------------
Temperature 41.35 C 74.00 C -4.00 C 70.00 C 0.00 C
Voltage 0.00 V 0.00 V 0.00 V 0.00 V 0.00 V
Current 8.10 mA 12.00 mA 4.00 mA 11.00 mA 5.00 mA
Tx Power -2.58 dBm 3.00 dBm -11.30 dBm -1.00 dBm -7.30 dBm
Rx Power -28.54 dBm -- 3.00 dBm -13.90 dBm -1.00 dBm -9.90 dBm
Transmit Fault Count = 7
----------------------------------------------------------------------------
Note: ++ high-alarm; + high-warning; -- low-alarm; - low-warning
Related Commands Command Description
show interface Displays the status of an interface.