Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-228
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show line
show line
To configure a virtual terminal line, use the show line command.
show line [com1 [user-input-string] | console [connected | user-input-string]]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays output from an MDS switch with a Supervisor-1 module.
switch# show line console
line Console:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Statistics: tx:12842 rx:366 Register Bits:RTS|CTS|DTR|DSR|CD|RI
The following example displays output from an MDS switch with a Supervisor-2 module.
switch# show line console
line Console:
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q0V1&D0&C0S0=1\015
Statistics: tx:12842 rx:366 Register Bits:RTS|CTS|DTR|DSR|CD|RI
com1 Displays aux line configuration.
user-input-string Displays the user-input initial string.
console Displays console line configuration.
connected Displays the physical connection status.
Release Modification
1.2(1) This command was introduced.
3.0(1) Modified examples for Supervisor-1 and Supervisor-2 modules.