Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
20-29
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 20 R Commands
rmon hcalarm
rmon hcalarm
To configure a 64-bit remote monitoring (RMON) high-capacity alarm (hcalarm), use the rmon hcalarm
command in configuration mode. To delete an rmon hcalarm, use the no form of the command.
rmon hcalarm alarm-number mib-object sample-interval {absolute | delta}
{rising-threshold-high value rising-threshold-low value [rising-event]
[falling-threshold-high value falling-threshold-low value [falling-event]] |
falling-threshold-high value falling-threshold-low value [falling-event]}
[owner alarm-owner]
no rmon hcalarm alarm-number
Syntax Description
Defaults 64-bit alarms.
Command Modes Configuration mode
Command History
alarm-number Specifies the RMON hcalarm number. The range is 1 to 65535.
mib-object Specifies the MIB object to monitor. Maximum length is 80 characters.
Note The MIB object identifier must be fully numbered, dotted-decimal
notation, not the text string description.
sample-interval Specifies the sample interval in seconds. The range is 1 to 65535.
absolute Tests each sample directly.
delta Tests the difference (delta) between the current and previous sample.
rising-threshold-high
value
Configures the upper 32 bits of the 64-bit rising threshold value. The range
is 0 to 4294967295.
rising-threshold-low
value
Configures the lower 32 bits of the 64-bit rising threshold value. The range
is 0 to 4294967295.
rising-event (Optional) Specifies the event to trigger on rising threshold crossing. The
range is 1 to 65535.
falling-threshold-high
value
Configures the upper 32 bits of the 64-bit falling threshold value. The range
is 0 to 4294967295.
falling-threshold-low
value
Configures the lower 32 bits of the 64-bit falling threshold value. The range
is 0 to 4294967295.
falling-event (Optional) Specifies the event to trigger on falling threshold crossing. The
range is 0 to 65535.
owner alarm-owner (Optional) Specifies an owner for the alarm. Maximum size is 80 characters.
Release Modification
3.0(1) This command was introduced.