Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
11-56
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ip route
ip route
To configure a static route, use the ip route command in configuration mode.
ip route ip-address subnet-mask [nexthop_ip-address] [interface {gigabitethernet slot /port |
mgmt 0 | port-channel channel-id | vsan vsan-id} | distance distance-number]
no ip route ip-address subnet-mask [nexthop_ip-address] [interface {gigabitethernet slot /port |
mgmt 0 | port-channel channel-id | vsan vsan-id} | distance distance-number]
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following examples shows how to configure a static route.
switch# config terminal
switch(config)# IP route 10.0.0.0 255.0.0.0 20.20.20.10 distance 10 interface vsan 1
Related Commands
ip-address Specifies the IP address for the route.
subnet-mask Specifies the subnet mask for the route.
nexthop_ip-address Specifies the IP address of the next hop switch.
interface Configures the interface associated with the route.
gigabitethernet slot /port Specifies a Gigabit Ethernet interface at a port and slot.
mgmt 0 Specifies the managment interface (mgmt 0).
port-channel channel-id Specifies a PortChannel interface. The range is 1 to 128.
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
distance distance-number Specifies the distance metric for this route. It can be from 0 to 32766.
Release Modification
1.0(2) This command was introduced.
Command Description
show ip route Displays the IP address routes configured in the system.