Send documentation comments to mdsfeedback-doc@cisco.com
15-12
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 15 M Commands
member (zoneset configuration submode)
member (zoneset configuration submode)
To configure zone set zone members, use the member command in zone set configuration submode. To
remove a zone set member, use the no form of the command.
member member-name
no member member-name
Syntax Description
Defaults None.
Command Modes Zone set configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to add a member zone to a zone set.
switch# config terminal
switch(config)# zoneset name Zoneset1 vsan 10
switch(config-zoneset)# member ZoneA
Related Commands
member-name Specifies the member name. Maximum length is 64 characters.
Release Modification
1.0(2) This command was introduced.
Command Description
show zone Displays zone information.
zoneset name Creates a zone set.
To Next Page
Loading...
