Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
11-22
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface bay | ext
interface bay | ext
To configure a Fibre Channel interface on a Cisco Fabric Switch for HP c-Class BladeSystem and on a
Cisco Fabric Switch for IBM BladeCenter, use the interface bay or interface ext command in
configuration mode.
interface {bay port | ext port}
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example configures Fibre Channel interface bay2 and enters interface configuration
submode.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# int bay 2
switch(config-if)#
Related Commands
bay port | ext port Configures a Fibre Channel interface on a port. The range is 0 to 48.
Release Modification
3.1(2) This command was introduced.
Command Description
show interface Displays an interface configuration for a specified interface.