Send documentation comments to mdsfeedback-doc@cisco.com
23-49
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
time-stamp
time-stamp
To enable FCIP time stamps on a frame, use the time-stamp command. To disable this command for the
selected interface, use the no form of the command.
time-stamp [acceptable-diff number]
no time-stamp [acceptable-diff number]
Syntax Description
Defaults Disabled.
Command Modes Interface configuration submode.
Command History
Usage Guidelines Access this command from the switch(config-if)# submode.
The time-stamp option instructs the switch to discard frames that are older than a specified time.
Examples The following example enables the timestamp for an FCIP interface.
switch# config terminal
switch(config)# interface fcip 50
switch(config-if)# time-stamp
switch(config-if)# time-stamp acceptable-diff 4000
Related Commands
acceptable-diff number Configures the acceptable time difference for timestamps in milliseconds.
The range is 500 to 10000.
Release Modification
1.1(1) This command was introduced.
Command Description
show interface fcip Displays the configuration for a specified FCIP interface.
To Next Page
Loading...
Need help?
General