Send documentation comments to mdsfeedback-doc@cisco.com
11-65
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ips netsim max-bandwidth-kbps
ips netsim max-bandwidth-kbps
To limit the bandwidth in kilobytes per second of a specified Gigabit Ethernet interface, use the ips
netsim max-bandwidth-kbps command in SAN extension tuner configuration submode.
ips netsim max-bandwidth-kbps bandwidth ingress gigabitethernet slot/port
Syntax Description
Defaults Disabled.
Command Modes SAN extension tuner configuration submode.
Command History
Usage Guidelines To use this command, you must enable the IP Network Simulator using the ips netsim enable command.
Examples The following example shows how to limit the interface bandwidth to 4500 Kbps.
switch# config terminal
switch(config)#
switch(config)# san-ext-tuner enable
switch(config)# exit
switch#
switch# ips netsim max-bandwidth-kbps 4500 ingress gigabitethernet 2/3
Related Commands
max-bandwidth-kbps
bandwidth
Specifies the bandwidth in kilobytes per second. The range is 1000 to
1000000.
ingress Specifies the ingress direction.
gigabitethernet
slot/port
Specifies the the slot and port number of the Gigabit Ethernet interface.
Release Modification
3.1(1) This command was introduced.
Command Description
show ips netsim Displays a summary of the interfaces that are currently operating in network
simulation mode.
ips netsim enable Enables the IP Network Simulator.
To Next Page
Loading...
Need help?
General