Send documentation comments to mdsfeedback-doc@cisco.com
21-113
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
system trace
system trace
To configure the system trace level, use the system trace command in configuration mode. To disable
this feature, use the no form of the command.
system trace bit-mask
no system trace
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines This command is used for debugging purposes.
Examples The following example shows how to configure the system trace level.
switch# config terminal
switch(config)# system trace 0xff
bit-mask Specifies the bit mask to change the trace level.
Release Modification
1.0(2) This command was introduced.
To Next Page
Loading...
Need help?
General