Cisco mds 9124 - fabric switch User Manual

Send documentation comments to mdsfeedback-doc@cisco.com
8-35
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fcip profile
fcip profile
To create and configure an FCIP profile, use the fcip profile command. To remove an FCIP profile, use
the no form of the command.
fcip profile profile-id
no fcip profile profile-id
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines When you perform this command, the CLI enters FCIP profile configuration mode.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example shows how to configure an FCIP profile.
switch## config terminal
switch(config)# fcip profile 5
switch(config-profile)#
Related Commands
profile-id Specifies a ID range from 1 to 255.
Release Modification
1.1(1) This command was introduced.
Command Description
show fcip profile Displays information about the FCIP profile.
interface fcip
interface_number
use-profile profile-id
Configures the interface using an existing profile ID from 1 to 255.
show interface fcip Displays an interface configuration for a specified FCIP interface.

Cisco mds 9124 - fabric switch Specifications

General

Brand	Cisco
Model	mds 9124 - fabric switch
Category	Switch
Language	English