Send documentation comments to mdsfeedback-doc@cisco.com
21-19
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
send
send
To send a message to all active CLI users currently using the switch, use the send command in EXEC
mode.
send message-text
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines This message is restricted to 80 alphanumeric characters with spaces.
Examples The following example sends a warning message to all active users about the switch being shut down.
switch# send Shutting down the system in 2 minutes. Please log off.
Broadcast Message from admin@excal-112
(/dev/pts/3) at 16:50 ...
Shutting down the system in 2 minutes. Please log off.
message-text Specifies the text of your message.
Release Modification
1.0(2) This command was introduced.
To Next Page
Loading...
