Send documentation comments to mdsfeedback-doc@cisco.com
6-7
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug callhome
debug callhome
To enable debugging for the Call Home function, use the debug callhome command in EXEC mode. To
disable a debug command, use the no form of the command or use the no debug all command to turn
off all debugging.
debug callhome {all | events | mts}
no debug callhome {all | events | mts}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines The debug callhome command, when used with the all parameter, displays the troubleshooting
information for both Call Home event traces and a dump of the messaging and transaction service (MTS)
messages that the Call Home function receives.
Note The debug Call Home function displays event traces for both successful and unsuccessful Call Home
e-mail transmissions.
Examples The following example displays the system output when the debug callhome events command is issued:
switch# debug callhome events
2005-03-09T05:37:21 2005 Mar 9 05:37:21 callhome: filling in name field with Test
2005 Mar 9 05:37:21 callhome: filling in the header list
2005 Mar 9 05:37:21 callhome: filling up the chassis list
2005 Mar 9 05:37:21 callhome: filling up the main body list
2005 Mar 9 05:37:21 callhome: filling up the fru list 2005 Mar 9 05:37:21 callhome:
Entering function do_event_correlation
2005 Mar 9 05:37:21 callhome: getting dest profiles for alert group test
2005 Mar 9 05:37:21 callhome: getting dest profiles for alert group cisco-tac
2005 Mar 9 05:37:21 callhome: Applying the event rule for destination profile full_txt
2005 Mar 9 05:37:21 callhome: Applying the event rule for destination profile short_txt
2005 Mar 9 05:37:21 callhome: Applying the event rule for destination profile xml 2005
Mar 9 05:37:21 callhome: Applying the event rule for destination profile basu
2005 Mar 9 05:37:21 callhome: Exiting function do_event_correlation
all Enables debugging for all Call Home features.
events Enables debugging for all Call Home events.
mts Enables debugging for all Call Home tx/rx packets of MTS
Release Modification
1.0(2) This command was introduced.
To Next Page
Loading...
Need help?
General