Send documentation comments to mdsfeedback-doc@cisco.com
14-21
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 14 L Commands
logging monitor
logging monitor
To set monitor message logging, use the logging monitor command. To negate the previously issued
command or to revert to factory defaults, use the no form of the command.
logging monitor severity level
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example sets terminal line (monitor) message logging at level 2.
switch## config terminal
switch(config)# logging monitor 2
Related Commands
logging monitor Sets message logging.
severity level 0-7 0-emerg;1-alert;2-crit;3-err;4-warn;5-notif;6-inform;7-debug
Release Modification
1.0(2) This command was introduced.
Command Description
show logging Displays logging configuration information.