Send documentation comments to mdsfeedback-doc@cisco.com
4-85
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
clear sdv
clear sdv
To clear specified SAN device virtualization parameters, use the clear sdv command in EXEC mode.
clear sdv {database vsan vsan-id | session vsan vsan-id | statistics vsan vsan-id}
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example shows how to clear SDV statistics.
switch# clear sdv statistics vsan 2
Related Commands
database Clears the SDV database.
vsan vsan-id Specifies the number of the VSAN. The range is 1 to 4093.
session Clears the SDV session.
statistics Clears the SDV statistics.
Release Modification
3.1(2) This command was introduced.
Command Description
sdv enable Enables or disables SAN device virtualization.
show sdv statistics Displays SAN device virtualization statistics.