Send documentation comments to mdsfeedback-doc@cisco.com
16-7
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 16 N Commands
no fc-redirect version2 enable
no fc-redirect version2 enable
To disable the version2 mode in FC-Redirect, use the no fc-redirect version2 enable command in
configuration mode.
no fc-redirect version2 enable
Syntax Description
Defaults None.
Command Modes Configuration mode
Command History
Usage Guidelines We recommend that you not disable version2 mode in FC-Redirect because it disables version2 mode
thoughtout the fabric.
Examples The following example shows how to disable version2 mode in FC-Redirect.
switch# no fc-redirect version2 enable
switch(config)# no fc-redirect version2 enable
WARNING: This command will disable Version2 mode throughout the fabric.
This is NOT a recommended step.
Do you want to continue? (Yes/No) [No] Yes
Before proceeding further, Please check the following:
1) There are No FC-Redirect configurations in the fabric.
You can use the command 'show fc-redirect configs' for the
purpose.
2) All the switches in the fabric are seen in the output of
'show fc-redirect peer-switches' command and are in 'UP' state.
3) All switches in the fabric are running SanOS version 3.3.x or
higher.
4) Please make sure the Fabric is stable ie.,
No fabric changes/upgrades in progress
Do you want to continue? (Yes/No) [No] Yes
This command has no arguments or keywords.
Release Modification
3.3(1a) This command was introduced.
To Next Page
Loading...
Need help?
General