Send documentation comments to mdsfeedback-doc@cisco.com
6-134
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug xbc
debug xbc
To enable crossbar client debugging (XBC), use the debug xbc command in EXEC mode. To disable a
debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug xbc {demux | deque | init | main}
no debug xbc {demux | deque | init | main}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines Use this command to debug crossbar client events and information.
Examples The following example displays the system output when the debug xbc init command is issued:
switch# debug xbc init
Related Commands
demux Enables debugging for crossbar demux functions.
deque Enables debugging for crossbar deque events.
init Enables debugging for crossbar initialization.
main Enables debugging for crossbar main functions.
Release Modification
1.0(2) This command was introduced.
Command Description
no debug all Disables all debugging.
To Next Page
Loading...
Need help?
General