Send documentation comments to mdsfeedback-doc@cisco.com
4-132
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
crypto ike domain ipsec rekey sa
crypto ike domain ipsec rekey sa
To rekey an IKE crypto security association (SA) in the IPsec domain, use the crypto ike domain ipsec
rekey sa command.
crypto ike domain ipsec rekey sa sa-index
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines To use this command, IKE must be enabled using the crypto ike enable command.
Note This command is not supported on the Cisco MDS 9124 switch.
Examples The following example rekeys an IKE crypto SA.
switch# crypto ike domain ipsec rekey sa 100
Related Commands
sa-index Specifies the SA index. The range is 1 to 2147483647.
Release Modification
2.0(x) This command was introduced.
Command Description
crypto ike enable Enables the IKE protocol.
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
To Next Page
Loading...
Need help?
General