Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
21-21
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
server (radius configuration)
server (radius configuration)
To configure a RADIUS server, use the server command in RADIUS configuration submode. To discard
the configuration, use the no form of the command.
server [ipv4-address | ipv6-address | dns-name]
no server [ipv4-address | ipv6-address | dns-name]
Syntax Description
Defaults None.
Command Modes RADIUS configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows the server command in RADIUS configuration submode.
switch# config terminal
switch(config)# aaa group server radius testgroup
switch(config-radius)# server myserver
Related Commands
ipv4-address Specifies the RADIUS server IP address in the format A.B.C.D.
ipv6-address Specifies the RADIUS server IP address in the format X:X::X.
name Specifies the RADIUS DNS server name. The maximum size is 255.
Release Modification
1.3(1) This command was introduced.
3.0(1) Added the ipv6-address argument.
Command Description
radius-server host Configures RADIUS server parameters.
show radius-server Displays RADIUS server configuration parameters.