Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
11-137
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ivr virtual-fcdomain-add2
ivr virtual-fcdomain-add2
To configure the request domain_ID (RDI) mode in a specific autonomous fabric ID (AFID) and VSAN
for all IVR-enabled switches, use the ivr virtual-fcdomain-add2 command. To delete the RDI mode,
use the no form of the command.
ivr virtual-fcdomain-add2 autonomous-fabric-id value vsan-ranges value
no ivr virtual-fcdomain-add2 autonomous-fabric-id value vsan-ranges value
Syntax Description
Defaults None.
Command Modes Configuration mode
Command History
Usage Guidelines This is a CFS distributable command.
Examples The following example configures the RDI mode on a specific AFID and VSAN.
switch# config
Enter configuration commands, one per line. End with CNTL/Z.
switch# ivr virtual-fcdomain-add2 autonomous-fabric-id 1 vsan-ranges 2
switch# fabric is now locked for configuration. Please 'commit' configuration when done.
switch(config)# ivr commit
Related Commands
fabric-id value Specifies the fabric ID on which the RDI mode needs to be configured.
vsan-ranges value Specifies the VSAN range value on which the RDI mode needs to be
configured.
Release Modification
3.3(1a) This command was introduced.
Command Description
show ivr
virtual-fcdomain-add-
status2
Displays the RDI mode in a specific AFID and VSAN for all IVR-enabled
switches.