Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
22-399
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show zoneset
show zoneset
To display the configured zone sets, use the show zoneset command.
show zoneset [[active [vsan vsan-id]] |
[brief [active [vsan vsan-id] | vsan vsan-id]] |
[name zoneset-name
[active vsan vsan-id] |
[brief [active vsan vsan-id | vsan vsan-id]] |
[pending [active vsan vsan-id | brief [active vsan vsan-id | vsan vsan-id] | vsan vsan-id]] |
[vsan vsan-id]] |
[pending
[active vsan vsan-id] |
[brief [active vsan vsan-id | vsan vsan-id]] |
[vsan vsan-id]] |
[vsan vsan-id]]
Syntax Description
Defaults None.
Command Modes EXEC mode
Command History
Usage Guidelines None.
Examples The following example displays configured zone set information.
switch# show zoneset vsan 1
zoneset name ZoneSet2 vsan 1
active Displays only active zone sets.
vsan Displays the VSAN.
vsan-id Specifies the ID of the VSAN. The range is 1 to 4093
brief Displays zone set members in a brief list.
name Displays members of a specified zone set.
zoneset-name Specifies the zone set name. The maximum is 64.
pending Displays zone sets members that are in session.
Release Modification
1.2(2) This command was modified.