Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
23-44
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 23 T Commands
telnet server enable
telnet server enable
To enable the Telnet server if you wish to return to a Telnet connection from a secure SSH connection,
use the telnet server enable command. To disable the Telnet server, use the no form of this command
telnet server enable
no telnet server enable
Syntax Description This command has no arguments or keywords.
Defaults Enabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example enables the Telnet server.
switch(config)# telnet server enable
updated
The following example disables the Telnet server.
switch(config)# no telnet server enable
updated
Related Commands
Release Modification
1.0(2) This command was introduced.
Command Description
telnet Logs in to a host that supports Telnet.