Send documentation comments to mdsfeedback-doc@cisco.com
4-88
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
clear system reset-reason
clear system reset-reason
To clear the reset-reason information stored in NVRAM and volatile persistent storage, use the clear
system reset-reason command in EXEC mode.
clear system reset-reason
Syntax Description This command has no arguments or keywords.
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines Use this command as listed below:
• In a Cisco MDS 9500 Series switch, this command clears the reset-reason information stored in
NVRAM and volatile persistent storage in the active and standby supervisor modules.
• In a Cisco MDS 9200 Series switch, this command clears the reset-reason information stored in
NVRAM and volatile persistent storage in the active supervisor module.
Examples The following example shows how to clear trusted SSH hosts.
switch# clear system reset-reason
Related Commands
Release Modification
1.3(2a) This command was introduced.
Command Description
show system reset-reason Displays system reset-reason information.
To Next Page
Loading...
