Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
4-106
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
cluster
cluster
To configure a cluster feature, use the cluster command.
cluster enable
Syntax Description
Defaults None.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example enables the Cisco SME clustering:
switch# config terminal
switch(config)# cluster enable
switch(config)#
enable Enables or disables a cluster.
Release Modification
3.2(2) This command was introduced.