Send documentation comments to mdsfeedback-doc@cisco.com
4-4
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
callhome test
callhome test
To simulate a CallHome message generation, use the callhome test command.
callhome test [inventory]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines You can simulate a message generation by issuing a callhome test command.
Examples The following example sends a test message to the configured destination(s):
switch# callhome test
trying to send test callhome message
successfully sent test callhome message
The following example sends a test inventory message to the configured destination(s)
switch# callhome test inventory
trying to send test callhome message
successfully sent test callhome message
Related Commands
inventory Sends a dummy CallHome inventory.
Release Modification
1.0(2) This command was introduced.
Command Description
callhome Configures Call Home functions.
show callhome Displays configured Call Home information.
To Next Page
Loading...
Need help?
General