Send documentation comments to mdsfeedback-doc@cisco.com
6-106
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 6 Debug Commands
debug scsi-target
debug scsi-target
To enable debugging for SCSI targets, use the debug scsi-target command in EXEC mode. To disable
a debug command, use the no form of the command or use the no debug all command to turn off all
debugging.
debug scsi-target {error | flow}
no debug scsi-target {error | flow}
Syntax Description
Defaults Disabled.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples The following example displays the system output when the debug scsi-target flow command is issued:
switch# debug scsi-target flow
Apr 28 21:11:52 vhbad: vhba_mts_handler: sdwrap_dispatch: retval:0
Apr 28 21:11:54 vhbad: vhbad_handle_timeout: timer:1 context:(nil)
Apr 28 21:12:06 vhbad: vhba_mts_handler: sysmgr_dispatch: retval:-1
Related Commands
error Enables debugging for SCSI target daemon error conditions.
flow Enables debugging for the SCSI target flow.
Release Modification
1.1(1) This command was introduced.
Command Description
no debug all Disables all debugging.
show scsi-target Displays information about existing SCSI target configurations.
To Next Page
Loading...
Need help?
General