Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
21-80
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 21 S Commands
switchport ingress-rate
switchport ingress-rate
To configure the port rate limit for a specified interface, use the switchport ingress-rate command in
interface configuration mode. Use the no form of the command to delete the configured switch port
information.
switchport ingress-rate limit
no switchport ingress-rate limit
Syntax Description
Defaults Disabled.
Command Modes Interface configuration submode.
Command History
Usage Guidelines Access this command from the switch(config-if)# submode. This command is only available if the
following conditions are true:
• The QoS feature is enabled using the qos enable command.
• The command is issued in a Cisco MDS 9100 series switch.
Examples The following example configures the ingress rate limit on a Fibre Channel interface.
switch# config terminal
switch(config)# interface fc 2/5
switch(config-if)# switchport ingress-rate 5
Related Commands
limit Specifies the ingress rate limit as a percentage. The range is 1 to 100.
Release Modification
1.3(1) This command was introduced.
Command Description
show interface fc Displays an interface configuration for a specified Fibre Channel interface.