Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
24-4
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 24 U Commands
use-profile
use-profile
To bind a profile to the FCIP interface, use the use-profile option. To disable a configured profile, use
the no form of the option.
use-profile profile-id
no use-profile profile-id
Syntax Description
Defaults None.
Command Modes Interface configuration submode.
Command History
Usage Guidelines Access this command from the switch(config-if)# submode.
This command binds the profile with the FCIP interface.
Examples switch# config terminal
switch(config)# interface fcip 50
switch(config-if)# use-profile 100
switch(config-if)# no use-profile 100
Related Commands
use-profile profile-id Specifies the profile ID to be used. The range is 1 to 255.
Release Modification
1.1(1) This command was introduced.
Command Description
show interface fcip Displays an interface configuration for a specified FCIP interface.
show fcip Displays information about the FCIP profile.