Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
2-18
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 2 A Commands
attribute qos
attribute qos
To configure a QOS attribute, use the attribute qos command in Inter-VSAN Routing (IVR) zone
configuration submode. To disable this feature, use the no form of this command.
attribute qos {high | low | medium}
no attribute qos {high | low | medium}
Syntax Description
Defaults Disabled.
Command Modes IVR zone configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to configure an IVR zone QOS attribute to low priority.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# ivr zone name IvrZone
switch(config-ivr-zone)# attribute qos priority low
Related Commands
high Configures frames matching zone to get high priority.
low Configures frames matching zone to get low priority (Default).
medium Configures frames matching zone to get medium priority.
Release Modification
2.1(1a) This command was introduced.
Command Description
show ivr zone Displays IVR zone configuration.