Send documentation comments to mdsfeedback-doc@cisco.com
4-144
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 4 C Commands
customer-id
customer-id
To configure the customer ID with the Call Home function, use the customer-id command in Call Home
configuration submode. To disable this feature, use the no form of the command.
customer-id customer-id
no customer customer-id
Syntax Description
Defaults None.
Command Modes Call Home configuration submode.
Command History
Usage Guidelines None.
Examples The following example shows how to configure the customer ID in the Call Home configuration
submode.
switch# config terminal
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# callhome
switch(config-callhome)# customer-id Customer1234
Related Commands
customer-id (Optional) Specifies the customer ID. The maximum length is 64
alphanumeric characters in free format.
Release Modification
1.0(2) This command was introduced.
Command Description
callhome Configures the Call Home function.
callhome test Sends a dummy test message to the configured destination(s).
show callhome Displays configured Call Home information.
To Next Page
Loading...
Need help?
General