Send documentation comments to mdsfeedback-doc@cisco.com
22-136
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 22 Show Commands
show install all impact
show install all impact
To display the software compatibility matrix of a specific image, use the show install all impact
command.
show install all impact [asm-sfn image-filename] [kickstart image-filename] [ssi image-filename]
[system image-filename]
Syntax Description
Defaults None.
Command Modes EXEC mode.
Command History
Usage Guidelines None.
Examples Use the show install all impact command to view the effect of updating the system from the running
image to another specified image.
switch# show install all impact
Verifying image bootflash:/ilc1.bin
[####################] 100% -- SUCCESS
Verifying image bootflash:/vk73a
[####################] 100% -- SUCCESS
Verifying image bootflash:/vs73a
[####################] 100% -- SUCCESS
Extracting “slc” version from image bootflash:/vs73a.
[####################] 100% -- SUCCESS
Extracting “slc” version from image bootflash:/vs73a.
[####################] 100% -- SUCCESS
Extracting “system” version from image bootflash:/vs73a.
[####################] 100% -- SUCCESS
asm-sfn Specifies the ASM SFN boot variable.
image-filename Specifies the name of an image.
kickstart Specifies the kickstart boot variable.
ssi Specifies the SSI boot variable.
system Specifies the system boot variable.
Release Modification
1.2(1) This command was introduced.
To Next Page
Loading...
Need help?
General