Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
11-136
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ivr virtual-fcdomain-add
ivr virtual-fcdomain-add
To add the Inter-VSAN Routing (IVR) virtual domains in a specific VSAN(s) to the assigned domains
list in that VSAN, use the ivr virtual-fcdomain-add command. To delete the IVR virtual domains, use
the no form of the command.
ivr virtual-fcdomain-add vsan-ranges vsan-range
no ivr virtual-fcdomain-add vsan-ranges vsan-range
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines Use the no ivr virtual-fcdomain-add command to remove the currently active domains from the
fcdomain manager list in a specified VSAN.
Examples The following command adds the IVR virtual domains in VSAN 1.
switch# config terminal
switch(config)# ivr virtual-fcdomain-add vsan-ranges 1
The following command reverts to the factory default of not adding IVR virtual domains.
switch# config terminal
switch(config)# ivr virtual-fcdomain-add vsan-ranges 1
Related Commands
vsan-ranges vsan-range Specifies the IVR VSANs or range of VSANs. The range of values for a
VSAN ID is 1 to 4093.
Release Modification
1.3(4) This command was introduced.
Command Description
show ivr virtual-fcdomain-add-status Displays the configured VSAN topology for a fabric.
ivr withdraw domain Removes overlapping domains.