Send documentation comments to mdsfeedback-doc@cisco.com
11-40
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
interface vsan
interface vsan
To configure a VSAN interface, use the interface vsan command. To remove a VSAN interface, use the
no form of the command.
interface vsan vsan-id
no interface vsan vsan-id
Syntax Description
Defaults Disabled.
Command Modes Configuration mode.
Command History
Usage Guidelines None.
Examples The following example selects a VSAN interface and enters interface configuration submode.
switch# config terminal
switch(config)# interface vsan 1
switch(config-if)#
Related Commands
vsan-id Specifies the VSAN ID. The range is 1 to 4093.
Release Modification
1.0(2) This command was introduced.
Command Description
show interface Displays interface configuration for specified interface.
To Next Page
Loading...
Need help?
General