Send documentation comments to mdsfeedback-doc@cisco.com
11-46
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 11 I Commands
ip address (FCIP profile configuration submode)
ip address (FCIP profile configuration submode)
To assign the local IP address of a Gigabit Ethernet interface to the FCIP profile, use the ip address
command. To remove the IP address, use the no form of the command.
ip address address
no ip address address
Syntax Description
Defaults Disabled.
Command Modes FCIP profile configuration submode.
Command History
Usage Guidelines To create a FCIP profile, you must assign a local IP address of a Gigabit Ethernet interface to the FCIP
profile.
Examples The following example assigns the local IP address of a Gigabit Ethernet interface to the FCIP profile.
switch# config terminal
switch(config)# fcip profile 5
switch(config-profile)# ip address 10.5.1.1
Related Commands
address Specifies the IP address.
Release Modification
1.3(1) This command was introduced.
Command Description
show fcip profile Displays information about the FCIP profile.
interface fcip
interface_number
use-profile profile-id
Configures the interface using an existing profile ID from 1 to 255.
show interface fcip Displays an interface configuration for a specified FCIP interface.
To Next Page
Loading...
Need help?
General