Cisco mds 9124 - fabric switch

Send documentation comments to mdsfeedback-doc@cisco.com
8-86
Cisco MDS 9000 Family Command Reference
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Chapter 8 F Commands
fspf enable vsan
fspf enable vsan
To enable FSPF for a VSAN, use the fspf enable command in configuration mode. To disable FSPF
routing protocols, use the no form of the command.
fspf enable vsan vsan-id
no fspf enable vsan vsan-id
Syntax Description
Defaults Enabled
Command Modes Configuration mode.
Command History
Usage Guidelines This command configures FSPF on VSANs globally.
Examples The following example enables FSPF in VSAN 5 and disables FSPF in VSAN 7.
switch## config terminal
switch(config)# fspf enable vsan 5
switch(config)# no fspf enable vsan 7
Related Commands
vsan vsan-id Specifies a VSAN ID. The range is 1 to 4093.
Release Modification
1.0(2) This command was introduced.
Command Description
fspf config vsan Configures FSPF features for a VSAN.
show fspf interface Displays information for each selected interface.